Switchgear Modernization

All works on modernization of complete distribution devices are performed on the basis of approved standard projects according to installation instructions. This approach makes it possible to carry out the modernization of the switchgear under operational conditions by the service personnel. As a rule, the cost of such work is 30-50% of the cost of a new factory-made switchgear, which is another argument in favor of retrofit. In the end, you get a practically new complete distribution device, having spent a minimum of time and money on it.

If you do not have a set of operational documentation that allows you to identify the type of complete switchgear (as a rule, so-called "concrete" chambers or a switchgear older than 40-50 years), a recommended modernization option can be offered by our specialists on the basis of more than eleven years of experience in carrying out such works.

During the modernization of the KRP, the question arises about the modernization of relay protection and automation. Depending on the current state of the operated RZiA and financial capabilities, it is possible to save (or resuscitate) the old RZiA set or to completely replace it with a device that fully meets today's requirements.

Together with the vacuum switch included in the typical (basic) switching module, the customer is supplied with all the necessary parts and assemblies (up to the fasteners). This allows us to install the equipment both by operating personnel and by representatives of our company, spending 3-6 hours on it.

To order, contact the contact numbers or use the Contact form.